Study of the Composite Action of FRP Floor Beams and RC Slab Under Flexural Loading

Abstract

In this chapter, the effect of different types of connections on the flexural behavior of FRP-concrete composite slab is studied using finite element software ABAQUS. The connection between the FRP beams and RC slab is made using shear connectors and adhesive bonding. Web and flange elements of I-beams are connected with cohesive layer, because it is the weaker portion in the FRP I-beams and is highly prone to fail under three-point loading. Accuracy of the numerical model is verified by comparing the results with published experimental study. Further, the parametric study is performed on beams having different size and spacing of shear connectors. Along with, failure and service load of hybrid beams is determined for different geometric configuration of I-beams and width of RC slab. The flexural response of hybrid FRP-concrete beams obtained from finite element software shows good agreement with experimental testing. It is observed that shear connectors help in improving the strength of concrete-FRP hybrid beams. With increasing the length of shear connectors there is slight improvement in the strength of beam. As density of shear connectors decreases, consequently flexural stiffness of the beam (initial slope of load–deflection curve) decreases. It is also noted that strength and stiffness of the hybrid beam increases with increase in the length of the shear connectors. From the flexural study of the beams having different width-to-thickness (B/t) ratio, it is observed that some beams having different B/t ratio have same failure and service loads, due to the pre-mature failure of the web-flange junction of the I-beams. Hence, it is stated that addition of RC slab enhances the flexural stiffness, i.e., service load and also enhances the strength of web-flange junction. Addition of reinforced concrete slab over the FRP I-beams, reduces the chances of local buckling of the flange and web of the I-beam.