Abstract:
The deterioration of physical and mechanical properties of bituminous materials that are attributable to the aging of bitumen is one of the major causes of reduction in service life of flexible pavements. Thermal-oxidation and photo-oxidation aging are the two major types of aging of bitumen. Heat and oxygen cause thermal-oxidative aging, whereas ultraviolet irradiation and oxygen causes ultraviolet photo-oxidative aging of bitumen. Aging of binder leads to significant changes in the chemical composition of bitumen resulting in reduction of cracking resistance of bituminous mixes because of hardening of bitumen. So, it is quintessential to reduce the rate of hardening of bitumen induced by aging for prevention of premature failure of flexible pavements. The type of bitumen used for production of bituminous mixes have a significant effect on aging resistance of bitumen. The bitumen can be modified by using different types of modifiers such as antioxidants, bio-oils, nanomaterials, polymers, rubber, and ultraviolet absorbers. In addition to this, the modifiers such as fillers, warm mix additives, and rejuvenators also affect the aging resistance of bitumen. However, the effectiveness of these modifiers in preventing the hardening of bitumen because of aging varies with type of aging. The modifiers that exhibit improvement in thermal-oxidative aging resistance of bitumen are found to be less effective in improvement in photo-oxidative aging resistance and vice-versa. So, it is imperative to understand the effectiveness of different types of bitumen modifiers for the prevention of thermal-oxidative and photo-oxidative aging of bitumen. This review documents the resistance of different types of modifiers to thermal-oxidative and photo-oxidative aging. Finally, the scope for future work based on the critical gaps identified from existing works is also provided to assist further research.